Routing Device Channels - Extron electronics AXI 02 AT User Manual

Routing Device Channels

In order for the AXI to receive audio from the network, audio subscriptions must be
established between the AXI and other Dante devices on the audio network. Audio
subscriptions are managed using the Dante Controller Network View page and the
Routing tab (see
top of the screen, and the receivers, listed vertically down the left side, form a matrix whose
intersections are the connection points between the transmitters and receivers.
To make the receiver-to-transmitter subscription (connection), click once on an
•
intersection. Once a subscription has been made, the corresponding subscription icon
will appear.
NOTE: AXI 02 AT supports up to two receive flows (unicast or multicast). Refer to
the Dante Controller User Guide for more information on flows.
• To remove a subscription, click on the icon at the intersection.
One of the following icons appears at each subscription intersection, indicating the status of
both the transmitter and receiver channels and the subscription:
Icon Description
Indicates an active subscription.
Indicates a pending subscription.
Indicates a broken subscription.
Indicates the transmitting device has been removed from the network or is
switched off.
See the Dante Controller User Guide, available at the
information.
Creating Subscriptions Between Transmitters and Receivers
1. Ensure the host PC and AXI are connected to the same network.
2. From the start menu select:
All Programs > Audinate > Dante Controller > Dante Controller
The Dante Controller - Network View screen opens.
Dante Controller auto-discovers Dante devices on the network and advertises itself to
allow other Dante-enabled devices to communicate with it. Transmitters connect to
receivers using the connection matrix.
figure 27 on page 25). The transmitters, listed horizontally along the
Audinate website, for additional
AXI 02 AT • Dante Controller 24