Chapter 9 Diagnostic; Overview; Diagnostic - ZyXEL Communications NSW Series User Manual

9.1 Overview

This chapter explains the Diagnostic screen. You can use this screen to help you identify problems.

9.2 Diagnostic

Click Management > Diagnostic in the navigation panel to open this screen. Use this screen to ping IP
addresses or run a traceroute.
Figure 46 Management > Diagnostic
The following table describes the labels in this screen.
Table 19 Management > Diagnostic
LABEL
Ping Test
IPv4
(NSW100 Series
only)
Count
IP Address/Host
Name
Trace Route Test
DESCRIPTION
Select this option if you want to ping an IPv4 address, and select vlan to specify the ID
number of the VLAN to which the Switch is to send ping requests. Otherwise, select - to send
ping requests to all VLANs on the NSW.
Enter the number of ICMP Echo Request (ping) messages the NSW continuously sends.
Type the IP address or host name of a device that you want to ping in order to test a
connection.
Click Ping to have the NSW ping the IP address.
NSW Series User's Guide
53
C
H A P T E R
Diagnostic
9