Chapter 5 Status; Status - ZyXEL Communications NSW Series User Manual

5.1 Status

The Status screen displays when you log into the NSW or click Status at the top right corner of the web
configurator. The Status screen displays general device information, system status, and its IP addresses.
Figure 31 Status
The following table describes the labels in this screen.
Table 6 Status
LABEL
Device Information
Device Type
Boot Version
System Name
Firmware
Version
System
Location
Serial Number
System Time
MAC Address
System Up
Time
Login Timeout
DESCRIPTION
This field displays the model name of the NSW.
This field displays the version number and date of the boot module that is currently on the NSW.
This field displays the name used to identify the NSW on any network.
This field displays the version number and date of the firmware the NSW is currently running.
This field displays the location configured for the NSW in the Nebula Control Center.
This field displays the serial number of the NSW. The serial number is used for device tracking and
control.
This field displays the current date and time in the UAG. The format is mm-dd-yyyy hh:mm:ss.
This field displays the MAC addresses of the NSW.
This field displays how long the NSW has been running since it last restarted or was turned on.
This field displays how many minutes a management session can be left idle before the session
times out. After it times out you have to log in with your password again.
NSW Series User's Guide
C
H A P T E R
32
5
Status