ZyXEL Communications NSW Series User Manual page 49

Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.
Click Management > Maintenance > Firmware Upgrade to view the screen as shown next.
Figure 44 Management > Maintenance > Firmware Upgrade
Type the path and file name of the firmware file you wish to upload to the NSW in the File Path text box
or click Browse to locate it. You must restart the NSW (manually or use Reboot System) to apply the new
firmware immediately. Firmware upgrades are only applied after a reboot. Click Upgrade to load the
new firmware.
After the firmware upgrade process is complete, see Basic Setting > System Info to verify your current
firmware version number.
Table 16 Management > Maintenance > Firmware Upgrade
LABEL DESCRIPTION
Name This is the name of the NSW that you're configuring.
Version The NSW has two firmware sets, Firmware 1 and Firmware 2, residing in flash.
•
•
•
Current Boot Image This displays which firmware is currently in use on the NSW (Firmware 1 or Firmware 2).
Config Boot Image Select which firmware (Firmware 1 or Firmware 2) should load, click Apply and reboot the
NSW to see changes, you will also see changes in the Current Boot Image field above as
well.
Apply Click Apply to save your changes to the NSW's run-time memory. The NSW loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Firmware Choose to upload the new firmware to (Firmware) 1 or (Firmware) 2.
Chapter 8 Maintenance
Running shows the version number (and model code) and MM/DD/YYYY creation date
of the firmware currently in use on the NSW (Firmware 1 or Firmware 2). The firmware
information is also displayed at System Information in Basic Settings.
Firmware 1 shows its version number (and model code) and MM/DD/YYYY creation
date.
Firmware 2 shows its version number (and model code) and MM/DD/YYYY creation
date.
NSW Series User's Guide
49