Ip Setup - ZyXEL Communications NSW Series User Manual

Table 7 Basic Setting > System Info (continued)
LABEL
MAX
MIN
Threshold
Status
Fan Speed
(RPM)
Current
MAX
MIN
Threshold
Status
Voltage(V)
Current
MAX
MIN
Threshold
Status

6.3 IP Setup

Use the IP Setup screen to configure the NSW IP address, default gateway device, and the
management VLAN ID. The default gateway specifies the IP address of the default gateway (next hop)
for outgoing traffic. Configure them so that the NSW can access the Internet through the gateway/
router in the network. Once the NSW can connect to the Internet, it can be managed by the NCC after
registration.
Figure 33 Basic Setting > IP Setup
Chapter 6 Basic Setting
DESCRIPTION
This field displays the maximum temperature measured at this sensor.
This field displays the minimum temperature measured at this sensor.
This field displays the upper temperature limit at this sensor.
This field displays Normal for temperatures below the threshold and Error for those above.
A properly functioning fan is an essential component (along with a sufficiently ventilated, cool
operating environment) in order for the device to stay within the temperature threshold. Each fan
has a sensor that is capable of detecting and reporting if the fan speed falls below the threshold
shown.
This field displays this fan's current speed in Revolutions Per Minute (RPM).
This field displays this fan's maximum speed measured in Revolutions Per Minute (RPM).
This field displays this fan's minimum speed measured in Revolutions Per Minute (RPM). "<41" is
displayed for speeds too small to measure (under 2000 RPM).
This field displays the minimum speed at which a normal fan should work.
Normal indicates that this fan is functioning above the minimum speed. Error indicates that this
fan is functioning below the minimum speed.
The power supply for each voltage has a sensor that is capable of detecting and reporting if the
voltage falls out of the tolerance range.
This is the current voltage reading.
This field displays the maximum voltage measured at this point.
This field displays the minimum voltage measured at this point.
This field displays the percentage tolerance of the voltage with which the NSW still works.
Normal indicates that the voltage is within an acceptable operating range at this point;
otherwise Error is displayed.
NSW Series User's Guide
36