Gui-Based Ftp Clients - ZyXEL Communications NSW Series User Manual

Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "assigned by the NCC" when the NSW is registered with
4
the NCC or "1234").
Enter bin to set transfer mode to binary.
5
Use put to transfer files from the computer to the NSW, for example, put firmware.bin ras transfers
6
the firmware on your computer (firmware.bin) to the NSW and renames it to "ras". Similarly, put
config.cfg config transfers the configuration file on your computer (config.cfg) to the NSW and
renames it to "config". Likewise get config config.cfg transfers the configuration file on the NSW to
your computer and renames it to "config.cfg". See
filename conventions.
Enter quit to exit the ftp prompt.
7

8.5.4 GUI-based FTP Clients

The following table describes some of the commands that you may see in GUI-based FTP clients.
General Commands for GUI-based FTP Clients
COMMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory
Initial Local Directory
Chapter 8 Maintenance
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the server for
anonymous access. Anonymous logins will work only if your ISP or service administrator
has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode. Configuration and
firmware files should be transferred in binary mode.
Specify the default remote directory (path).
Specify the default local directory (path).
NSW Series User's Guide
52
Table 18 on page 51 for more information on