ZyXEL Communications NSW Series User Manual page 17

Screw the two screws provided with your NSW into the wall 135 mm apart (see
1
See Figure 11 on page 18
Do not screw the screws all the way in to the wall; leave a small gap between the head of the screw
and the wall.
The gap must be big enough for the screw heads to slide into the screw slots and the connection cables
to run down the back of the NSW.
Note: Make sure the screws are securely fixed to the wall and strong enough to hold the
weight of the NSW with the connection cables.
Align the holes on the back of the NSW with the screws on the wall. Hang the NSW on the screws.
2
Figure 10 Wall-mounting Example
The NSW should be wall-mounted horizontally. The NSW's side panels
with ventilation slots should not be facing up or down as this position is
less safe.
The following are dimensions of a self-tapping screw and masonry plug used for wall mounting. All
measurements are in millimeters (mm).
Chapter 2 Hardware Installation and Connection
for the size of screws to use.
NSW Series User's Guide
17
Figure 10 on page 17).