Genie S-60X Operator's Manual page 57

Second Edition • First Printing
Installation of Padding
1 Install the 2 pieces of padding on the platform
rails. Position the padding to protect the panels
from contact with the platform rails.
Installation of Strap
1 Open the clamp and install it around a vertical
platform rail tube.
2 Insert a bolt with a washer through one side of
the clamp.
3 Install the strap assembly end plate onto the
bolt.
4 Insert the bolt through the other side of the
clamp.
5 Secure with a washer and a nut. Do not
over-tighten. The strap assembly end plate
should be able to slide on the platform rail.
Panel Cradle Operation
1 Secure both panel cradles to the platform.
2 Place the load so that it rests in both panel
cradles.
3 Center the load on the platform.
4 Secure the load to the platform using the strap.
Tighten the strap.
Part No. 1261735
Operating Instructions
rubber
bumper 1
decal
hook piece
padding
clamp
hook
S-60X
Operator's Manual
rubber
bumper 2
U-bolt
mounting
slots
panel
cradle
base
55