Genie S-60X Operator's Manual page 39

Second Edition • First Printing
Test the Oscillating Axle (if equipped)
39 Start the engine from the platform controls.
40 Drive the right steer tire up onto a 6 in / 15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
41 Drive the left steer tire up onto a 6 in / 15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground.
42 Drive both steer tires up onto a 6 in / 15 cm
block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Part No. 1261735
Test the Drive Enable System
43 Press down the foot switch and lower the
boom to the stowed position.
44 Rotate the turntable until the boom moves past
one of the non-steer wheels.
Result: The drive enable
indicator light should come
on and remain on while the
boom is anywhere in the
range shown.
45 Move the drive control handle off center.
Result: The drive function should not operate.
46 Move and hold the drive enable toggle switch
to either side and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that
the drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform
controls and the drive chassis
to identify the direction of
travel.
S-60X
Operator's Manual
Inspections
37