Backplane - Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual

Figure 53. Installing a hot-swap power supply
3. Check the status LED near the power cord connector. For information about the status LEDs, see "Hot-
swap power supply status LEDs" on page 26.

Backplane

This topic applies only to server models that have hot-swap storage drives installed.
• "Removing the backplane" on page 83
• "Installing the backplane" on page 84
Notes:
• The backplane is sensitive to ESD. Ensure that you read and understand "Handling static-sensitive
devices" on page 54 first and carefully perform the operation.
• The removing or installing procedure is based on the backplane for up to four 3.5-inch drives. The
procedure is similar if your server is installed with the backplane for up to eight 2.5-inch drives.
Removing the backplane
To remove the backplane, do the following:
Watch the procedure. A video of the removing process is available at:
• Youtube:
https://youtu.be/zOnZff3sXMQ
• Youku:
http://v.youku.com/v_show/id_XMjYwODcyMDE5Mg==.html?&f=49135033&from=y1.2
1. Prepare your server and remove the server cover. See "Preparing your server in advance and removing
the server cover" on page 55.
2. Remove the front bezel. See "Removing the front bezel" on page 57.
3. Remove the front system fan 1. See "Removing the front system fan 1" on page 91.
0
M
G M
T
1
2
1
3
4
2
ID
.
Chapter 5 Replacing hardware
83