Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual page 99

Figure 58. Removing the non-hot-swap power supply
4. If you are instructed to return the old non-hot-swap power supply, follow all packaging instructions and
use any packaging materials that are supplied to you for shipping.
Installing the non-hot-swap power supply
To install the non-hot-swap power supply, do the following:
Watch the procedure. A video of the installation process is available at:
• Youtube:
https://youtu.be/QcqzkFDj3MM
• Youku:
http://v.youku.com/v_show/id_XMjYwODcwNzAzMg==.html?&f=49135033&from=y1.2
1. Prepare your server and remove the server cover. See "Preparing your server in advance and removing
the server cover" on page 55.
2. If needed, remove the non-hot-swap power supply. See "Removing the non-hot-swap power supply" on
page 86.
3. Install the new non-hot-swap power supply into the chassis so that the four screw holes in the new non-
hot-swap power supply are aligned with the corresponding holes in the rear of the chassis. Then, install
the four screws to secure the new non-hot-swap power supply in place.
2
1
0
M
G M
T
1
2
1
3
4
2
ID
.
Chapter 5 Replacing hardware
87