Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual page 78

Notes:
• The server has two optical drive bays. If the server has only one optical drive installed, ensure that the
optical drive is installed in the lower bay (optical drive bay 1). The upper bay is for a secondary optical
drive only.
• Depending on the model, your server might look slightly different from the illustrations in this topic.
Removing the optical drive
To remove the optical drive, do the following:
Watch the procedure. A video of the removing process is available at:
• Youtube:
https://youtu.be/hnoidMuPYzs
• Youku:
http://v.youku.com/v_show/id_XMjYwODc2Njg2MA==.html?&f=49135033&from=y1.2
1. Prepare your server and remove the server cover. See "Preparing your server in advance and removing
the server cover" on page 55.
2. Open the front door (available on some models).
3. Disconnect cables from the rear of the optical drive.
4. Gently pull the metal tab on the side of the chassis and push the optical drive outward from the rear.
Then, draw the optical drive out of the chassis.
Figure 31. Removing the optical drive
5. If you are not going to install a new drive, install an EMI-protective shield in the vacant drive bay.
6. If you are instructed to return the old optical drive, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
Installing the optical drive
To install the optical drive, do the following:
66
ThinkServer TS460 User Guide and Hardware Maintenance Manual
1
2