1
Power connector on the rear of the secondary optical drive
2
SATA connector on the rear of the secondary optical drive
3
Power connector on the rear of the primary optical drive
4
SATA connector on the rear of the primary optical drive
5
SATA ODD connector 2 on the system board
6
SATA ODD connector 1 on the system board
Connecting cables for the tape drive
Note: The server configuration with a non-hot-swap power supply is used as an example. Your server might
come with two hot-swap redundant power supplies and a power distribution board.
If you are using an RDX tape drive, connect the power and signal cables for the tape drive as shown.
Figure 92. Connecting the cables for the RDX tape drive
1
Power connector on the rear of the RDX tape drive
2
Signal cable connector on the rear of the RDX tape drive
3
USB 2.0 connector on the system board
If you are using an LTO-6 or LTO-7 tape drive, connect the power and signal cables for the tape drive as
shown.
116
ThinkServer TS460 User Guide and Hardware Maintenance Manual
3
1 2