Connecting Cables For The Non-Hot-Swap Drives - Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual

Figure 93. Connecting the cables for the LTO-6 or LTO-7 tape drive
1
Power connector on the rear of the LTO-6 or LTO-7 tape drive
2
Signal cable connector on the rear of the LTO-6 or LTO-7 tape drive
3
Mini-SAS signal cable connector on the HBA card

Connecting cables for the non-hot-swap drives

Note: The server configuration with a non-hot-swap power supply is used as an example. Your server might
come with two hot-swap redundant power supplies and a power distribution board.
Connect the power and signal cables for the non-hot-swap drives as shown.
Figure 94. Connecting the power and signal cables
3
9 10
11 12
1 2
8 7 6 5
4 3 2
.
Chapter 5 Replacing hardware
117