Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual page 131

6
SATA connector 3 on the system board (for connector 3 of the SATA cable)
7
SATA SGPIO connector on the system board
If your server comes with one 2.5-inch-drive backplane, connect the power and signal cables as shown.
Note: The server configuration with a non-hot-swap power supply is used as an example. Your server might
come with two hot-swap redundant power supplies and a power distribution board.
Figure 96. Cable connection for one 2.5-inch-drive backplane
1
Power connector on the backplane
2
Mini-SAS cable connector 0 on the backplane
3
Mini-SAS cable connector 1 on the backplane
4
Connector 1 on the RAID card
5
Connector 0 on the RAID card
If your server comes with two 3.5-inch-drive backplanes, connect the power and signal cables as shown.
5 4
1
3
.
Chapter 5 Replacing hardware
119