Lenovo ThinkServer TS460 User Manual And Hardware Maintenance Manual page 123

Installing the power distribution board
To install the power distribution board, do the following:
Watch the procedure. A video of the installation process is available at:
• Youtube: https://youtu.be/TtmcLqZBKSk
• Youku: http://v.youku.com/v_show/id_XMjYwODcxNTI2OA==.html?f=49135033&from=y1.2-3.2
1. Prepare your server and remove the server cover. See "Preparing your server in advance and removing
the server cover" on page 55.
2. Lay the server on its side for easier operation.
3. Remove the hot-swap redundant power supply. See "Removing a hot-swap power supply" on page 81.
4. Hold the power distribution board by its edges and position it to the power supply cage. Ensure that four
tabs on the power supply cage are inserted into the corresponding holes in the power distribution board.
Then, pull the power distribution board inward.
Figure 85. Installing the power distribution board
5. Position power distribution board cage to the power supply cage. Ensure that the hole in the power
distribution board cage is aligned with the one in the power supply cage. Then, install the screw to
secure the power distribution board cage.
.
Chapter 5 Replacing hardware
111