Panasonic K-NL404K/G User Manual page 89

Period: Click setup button, you can see an interface is shown as in Figure 4-82. Here you can set

motion detect period. System only enables motion detect operation in the specified periods. It is not
for video loss or the tampering. There are two ways for you to set periods. Please note system only
supports 6 periods in one day.
Alarm Out: when an alarm occurs, system enables peripheral alarm devices.

Latch: when motion detection complete, system auto delays detecting for a specified time. The value

ranges from 1-300(Unit: second)
Show Message: System can pop up a message to alarm you in the local host screen if you enabled

this function.
Alarm Upload: System can upload the alarm signal to the network (including alarm centre) if you

enabled current function.
Send Email: System can send out email to alert you when an alarm occurs.

Record Channel: System auto activates motion detection channel(s) to record once an alarm occurs.

Please make sure you have set MD record in Schedule interface(Main
Menu->SETTING->SCHEDULE) and schedule record in manual record interface(Main
Menu->ADVANCED->MANUAL RECORD)
PTZ Activation: Here you can set PTZ movement when an alarm occurs. Such as go to preset, tour

&pattern when there is an alarm. Click "Setup" button, you can see an interface is shown as in
Figure 4-80
.
X
Record Delay: System can delay the record for specified time after alarm ended. The value ranges

from 10s to 300s.
Tour: Here you can enable tour function when alarm occurs. System one-window tour.

 Snapshot: You can enable this function to snapshot image when a motion detect alarm occurs.
Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.

Please highlight icon
button, system goes back to the previous menu.
Note:
In motion detection mode, you cannot use copy/paste to set channel setup since the video in each
channel may not be the same.
In Figure 4-79, you can left click mouse and then drag it to set a region for motion detection. Click FN to
switch between arm/withdraw motion detection. After setting, click ENTER button to exit.
to select the corresponding function. After all the setups please click save
83