Panasonic K-NL404K/G User Manual page 51

PTZ Type: There are two types: local/remote. Please select local mode if you are connect RS485

cable to connect to the Speed dome (PTZ). Please select remote mode if you are connecting to the
network PTZ camera.
Protocol: Select corresponding PTZ protocol(such as PELCOD)

Address: Default address is 1.

Baud Rate: Select corresponding baud rate. Default value is 9600.

Data Bit: Select corresponding data bits. Default value is 8.

Stop Bit: Select corresponding stop bits. Default value is 1.

Parity: There are three options: odd/even/none. Default setup is none.

If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 4-37.
Figure 4-36
45