Network; Tcp/Ip - Panasonic K-NL404K/G User Manual

4.11 Network

4.11.1 TCP/IP

The single network adapter interface is shown as in Figure 4-98 .
IP Version: There are two options: IPv4 and IPv6. Right now, system supports these two IP address

format and you can access via them.
MAC Address: The host in the LAN can get a unique MAC address. It is for you to access in the LAN. It is

read-only.
IP Address: Here you can use up/down button or input the corresponding number to input IP address.

Then you can set the corresponding subnet mask the default gateway.
Default Gateway: Here you can input the default gateway. Please note system needs to check the

validity of all IPv6 addresses. The IP address and the default gateway shall be in the same IP
section. That is to say, the specified length of the subnet prefix shall have the same string.
DHCP: It is to auto search IP. When enable DHCP function, you cannot modify IP/Subnet mask

/Gateway. These values are from DHCP function. If you have not enabled DHCP function, IP/Subnet
mask/Gateway display as zero. You need to disable DHCP function to view current IP information.
Besides, when PPPoE is operating, you cannot modify IP/Subnet mask /Gateway.
MTU: It is to set MTU value of the network adapter. The value ranges from 1280-7200 bytes. The

default setup is 1500 bytes. Please note MTU modification may result in network adapter reboot and
network becomes off. That is to say, MTU modification can affect current network service. System
may pop up dialog box for you to confirm setup when you want to change MTU setup. Click OK
Figure 4-96
99