Panasonic K-NL404K/G User Manual page 176

5.8.1.4 ENCODE
5.8.1.4.1 Encode
The encode interface is shown as below. See Figure 5-22.
Please refer to the following sheet for detailed information.
Parameter
Channel
Video Enable
Code-Stream
Type
Compression
Resolution
Frame Rate
Bit rate type
Figure 5-22
Function
Please select a channel from the dropdown list.
Check the box here to enable extra stream video. This item is
enabled by default.
It includes main stream, motion stream and alarm stream. You
can select different encode frame rates form different recorded
events.
System supports active control frame function (ACF). It allows
you to record in different frame rates.
For example, you can use high frame rate to record important
events, record scheduled event in lower frame rate and it allows
you to set different frame rates for motion detection record and
alarm record.
The main bit stream supports H.264, H.265. The extra stream
supports H.264, H.265, MJPEG.
The resolution here refers to the capability of the network
camera.
PAL：1 - 25fps; NTSC：1 - 30fps.
System supports two types: CBR and VBR.
set frame rate to change video quality. The higher the frame rate
is, the better the video quality is. The referenced bit rate is the
recommended value.
170
Main stream: It is to
Sub stream: In CBR