Panasonic K-NL404K/G User Manual page 56

4.6.2.2 Call PTZ Function
Call Preset
In Figure 4-41, input preset value and then click
Call Pattern
In Figure 4-41, input pattern value and then click
call.
Call Tour
In Figure 4-41, input tour value and then click
Call Scan
In Figure 4-41, input autoscan value and then click
call.
Autopan
In Figure 4-41, click
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:
Preset, tour and pattern all need the value to be the control parameters. You can define it as you

require.
You need to refer to your camera user's manual for Aux definition. In some cases, it can be used for

special process.
Aux
Click , system goes to the following interface. The options here are defined by the protocol. The
aux number is corresponding to the aux on-off button of the decoder. See Figure 4-45.
to enable the camera to rotate.
Figure 4-45
50
to call a preset. Click
to call a pattern. Click
to call a tour. Click again
to call a tour. Click again
again to stop call.
again to stop
to stop call.
to stop