Table of Contents
Advertisement
installation
optional media - crushed glass and volcanic stone installation
A combination of glass crystals and volcanic stones can be installed on the
burner as an option to the log set.
Shut off the gas and electrical supply.
1. Remove the safety screen and open the front door of the unit.
2. Remove the 3 screws holding the Burner Assembly to the firebox base. Lift
burner straight up and lift out to remove.
3. Remove the 6 log pins from the burner, remove the burner and flip over
remove the 6 six screws in locations shown below.
| RC500E
54
4. Re-install burner.
5. Spread the crushed glass evenly on the burner and place the volcanic
stones as shown below - do not block the burner ports with the volcanic
stones.
Optional Media on Burner
3.5lb
12
Optional Media on Burner - Glass only
3.5lb
Crushed glass only installation showing exact
same steps as above with exception of volcanic
stones.
3/4" crushed glass
Volcanic stones
3/4" crushed glass
Hide quick links:
Advertisement
Table of Contents
