Wiring Diagram Without Thermostat - Regency Contura RC500E Owners & Installation Manual

installation

wiring diagram without thermostat

If any of the original wires as supplied with the appliance must be replaced, it must be replaced with CSA type SEW (200
This heater does not require a 120V A.C. supply for operation. In case of a power failure, the burner switch and the optional remote control/thermostat will
continue to operate. However, a 120V A.C. power supply is needed for the fan/blower operation.
WARNING:
Electrical Grounding
Instructions
This appliance is equipped with
a three pronged (grounding) plug
for your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not
cut or remove the grounding
prong from this plug.
BATTERY
HOLDER
YELLOW/GREEN
ORANGE
GREEN
RESET SWITCH
| RC500E
56
This heater does not require a 120V A.C. supply
for operation. In case of a power failure, the re-
mote control/thermostat will continue to operate.
However, a 120V A.C. power supply is needed
for the fan/blower operation.
SPARK
FLAME DETECT
GREY
GREY
ON/OFF SWITCH
BLACK
BROWN
YELLOW
ORANGE
BLACK
BLACK
ON/OFF
BAT -/+
IPI/CPI
APS
EV GND
EV P/M
MOTOR
SPLIT FLOW
RED
BLACK
YELLOW
YELLOW
LOAD
C) or its equivalent.
o
CAUTION:
Ensure that the wires do
not touch a hot surface and are away
from sharp edges.
Note:
4 AA Batteries must be installed into the back
up battery compartment however for this unit
to operate when power is lost. See battery
back up instructions in this manual The fan
and or lights will not operate during a power
outage.
GREEN
BLACK
BLACK
RED
BLACK
BLACK WHITE
BLACK
WHITE
BLACK
WHITE
WHITE
BLACK
MAIN
LINE
FAN