Enamel Panel Installation - Regency Contura RC500E Owners & Installation Manual

installation

ENAMEL PANEL INSTALLATION

enamel panel installation
1. Shut off the unit and allow to cool to room temperature.
2. Lift off the front safety screen (if installed) and open the front
door (see details in manual).
3. Remove the logs, and any media (if already installed).
4. Remove the front grill - see manual.
5. Remove the 3 screws holding the Burner Assembly to the
firebox base. Lift burner straight up and lift out to remove.
6. Loosen 2 screws in locations shown below.
7. Lift heat baffle up off screws and remove from unit.
Profile of heat baffle
| RC500E
48
919-893
8. The same screws that released the baffle will release the
steel inner panel.
tooltip
9. Lift panel up off the screw and rotate to remove from the unit.
tooltip
10. Replace steel inner panel with enamel panel.
11. Reinstall top heat baffle and secure both enamel panel and
baffle with screws loosened in Step 3.
12. Reverse Steps 5-1.
RC500E
08.09.18