Owner's Information; Remote/Receiver Coding - Regency Contura RC500E Owners & Installation Manual

owner's information

Remote/Receiver coding

To code the receiver to the hand held remote, follow
the procedure below.
1. Open the lower door on the unit.
2. Plug in 120 volt power cord into a grounded
receptacle or install 4 AA batteries into battery
pack and plug into battery terminals located near
the gas valve. Do not use both. Only use the 4
AA batteries if 120 volt power is not available.
3. Install 3 AAA batteries into handheld remote.
4. Hold down the black reset button on the left
side (when facing unit) until 3 beeps are heard.
5. Hold down the ON/OFF button on the hand held
remote to code the remote to the receiver–after
4 beeps are heard–handheld is paired with
receiver.
| RC500E
8
tooltip
tooltip
Reset
button
ON / OFF
switch