Section 2: Framing - Montigo H36PVN Installation & Maintenance Manual

Section 2: Framing

Step 1. To frame in the unit first frame a rough-in enclosure with
combustible framing materials, using typical framing practices. The
rough-in frame opening for the assembled fireplace is 46" wide, x
50" high x 24" deep. See Figure 2.
46"
50"
(minimum)
Figure 2. Fireplace installation (combustible frame dimensions)
Step 2. Place the Fireplace in the enclosure and install the Vent pipe,
and Power Vent module. Next, Connect the Gas line and provide a
gas service shut-off valve; according to local gas codes, then secure
incoming gas
connection
Figure 2a. Fireplace installation, (Inlet Gas & Power Vent) .
Note: Images are shown without screens for clarity purposes.
However, your fireplace should not be operated without proper
installation of screens.
XG0649 - 180130
Installation
24"
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF CANADIAN HEATING PRODUCTS. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF CANADIAN HEA
Non-combustible Header (supplied by montigo), install to allow
15½" of Non-combustible cement board to fasten above the
glass of the unit and Non-combustible header.
Flexible
H36PVN Power Vent Indoor Gas Fireplace
NOTE: When constructing the framed opening, please ensure
that your combustible 2 x 4 header is at 50" minimum and
that there is access to install the gas line when the unit is
installed. See Figures 1 and 2a.
1"
Figure 2.aa Fireplace corner installation (combustible frame dimensions)
in place with 1/4" wood screws. Install supplied Non-combustible
header at 45½" from floor.
Secure nailing
flange to 2 x 4's
using ¼" wood
screws.
DIM ARE IN INCHES NAME DATE
FRACTIONAL 1/8
DRAWN CF 7/18/2016
X.XX .015
3/26/2018
X.XXX .005 CHECKED CF
ANGULAR: 1
THIRD ANGLE PROJECTION
UNLESS OTHERWISE SPECIFIED
ALL BENDS ARE 90
Page 7
H36PVFU
FULL
SIZE
DWG. NO.
A
1:1
SCALE: