Canon MF8580Cdw Service Manual page 264

4
Disassembly/Assembly > Controller System > Removing the High Voltage Power Supply PCB > Procedure
2) Remove the Harness [1].
• 1 Connector [2]
• Harness Guide [A]
[2]
3) Remove the Sub PCB [1].
4) Free the harness [3] from the harness guide [2].
• 1 screw [4]
4 Disassembly/Assembly > Controller System > Removing the High Voltage Power Supply PCB > Procedure
[1] [A]
F-4-434
[1]
[4]
[3] [2]
F-4-435
5) Remove the High Voltage Power Supply PCB [1].
• 3 screws (binding) [2]
• 1 screw (W SEMS) [3]
• 6 claws [4]
x4
x6
[4]
[2]
CAUTION:
When installing the High Voltage Power Supply PCB [1], be sure to check that the
contact springs [3] are in contact with the 20 round holes.
[1]
4-194
[4]
[2]
[1]
[2]
[3]
[4]
F-4-436
[2] [3]
F-4-437
4-194