Ats0 Set Number Of Rings Before Automatically Answering The Call - Siemens TC35i User Manual

TC35i AT Command Set
7.11 ATS0
7.11 ATS0 Set number of rings before automatically answering the
call
Syntax
Read Command
ATS0?
Response(s)
<n>
OK
Write Command
ATS0=<n>
Response(s)
OK
PIN ASC0 MUX1
! % %
Reference(s)
V.25ter
Command Description
This parameter setting determines the number of rings before automatic answering.
Parameter Description
(num)(&W)(&V)
<n>
(&F)
000
001-255
Notes
• This command works for MT data, fax and voice calls.
• Autoanswering of CSD data and fax calls is supported on ASC0/Mux1 only.
• If is set to higher values, the calling party may terminate the call establishment before the call can be
<n>
automatically answered.
• The correlation between
Example: ATS7=30 and ATS0=20 may not allow call establishment.
• Setting is local to the interface. It is allowed to have different settings on different interfaces. In such cases
the interface 'wins', which is idle and uses the smallest
TC35i_ATC_V02.07
Confidential / Released
MUX2 MUX3
% %
automatic answering is disabled
enable automatic answering on the specified ring number
and is important.
ATS7 ATS0
Page 158 of 439
value.
<n>
s
m
obile
1/30/04