Siemens TC35i User Manual page 90

TC35i AT Command Set
4.4 AT%D
To enable auto dialling for data and voice calls after ME's power on it is necessary to disable PIN authorization
with the command
AT+CLCK
mended to limit its network facilities. For details refer to the "FD" parameter of
If dialling starts on DTR line activation, possible responses are as though the dial command were entered by a
TE, for instance:
• OK
If successfully connected and voice call
• CONNECT<text>
If successfully connected and non-voice call. <text> is sent out if parameter setting is
data state.
• +CME ERROR: SIM not inserted
SIM card is needed to set up data and voice calls.
• +CME ERROR: SIM PIN required
PIN is required to set up data and voice calls.
• +CME ERROR: not found
Phone book entry is required for data and voice calls, but no telephone number is provided.
• NO DIALTONE
If there is no dialtone and parameter setting
• BUSY
If busy and parameter setting
• NO CARRIER
If a connection cannot be set up or call is finished by other party.
Parameter Description
(num)(&W)
<mode>
Auto dial state on DTR activation (OFF-ON transition).
Additional functionality is available with
be done with parameter
(&F)
[0]
1
(str)(&W)
<dialType>
Determine type of performed dial.
(&F)
[""]
";"
"!"
Notes
• To suppress arbitrary call releases on DTR deactivation setting of
• If several AT commands are entered on the same line
TC35i_ATC_V02.07
Confidential / Released
="SC",0,
<password>
ATX
3 or 4.
ATX ATX
AT^SCFG
set to "
<AutoExecATC>
Disable functionality.
Enable dialling of the telephone number located at index "1" in the "ME" phone
book. If
<dialType>
.
AT+CPBW
If omitted performed dial command leads to a data call.
Performed dial command leads to a voice call.
Dial command leads to an emergency call, i.e. ATD "112"; is performed. No
SIM card needs to be inserted in this case.
CAUTION!
1! setting especially in conjunction with
AT%D
emergency call setups.
Page 90 of 439
. To prevent misuse of this unprotected SIM card it is recom-
2 or 4.
ATX
, e.g. sending a short message (SMS) on DTR activation can
=1".
AT+CMSS
is "!" an emergency call is set up. Refer to
AT&D
needs to be the last one.
AT%D
s
m
.
AT+CLCK
>0. TA switches to
ATX
AT+CPBS
can easily lead to erroneous
AT&W
0 is strongly recommended.
obile
and
1/30/04