Siemens TC35i User Manual page 144

TC35i AT Command Set
7.2 ATD
Using during an active call:
ATD
• When a user originates a second voice call whil there is already an active voice call, the first call will automat-
ically put on hold. The second call attempt is acknowledged with "OK" immediately after dialing with ATD has
completed, without relation to a successful call setup. In case of failure, the additional result codes "NO CAR-
RIER", "NO DIAL TONE", "NO CARRIER" will be presented afterwards (see example below).
Parameter Description
(text)
<n>
String of dialing digits and optional V.25ter modifiers: 0-9, *, #, +, A, B, C
The following V.25ter modifiers are ignored: ,(comma), T, P, !, W ,@
Emergency call: <n> = 112 standardized GSM emergency number (no SIM needed).
(str)
<mgsm>
String of GSM modifiers:
I Activates CLIR (disables presentation of own phone number to called party)
i Deactivates CLIR (enables presentation of own phone number to called party)
G Activate Closed User Group explicit invocation for this call only.
g Deactivate Closed User Group explicit invocation for this call only.
Notes
• The command may be aborted generally when receiving an
aborted in some connection setup states, such as handshaking.
• Parameter "I" and "i" only if no *#-code is within the dial string.
• is not supported for data calls.
<mgsm>
• is default for last number that can be dialled by
<n>
• See also for
ATX <text>
• If is used with a USSD command (e.g. ATD*100#;) an AT+CUSD=1 is executed implicitly (see
ATD
• Parameter 'G' or 'g' will be ignored if Closed User Group was already activated, respectively deactivated with
command before. Call by call invocation of CUG uses the settings provisioned by the provider or,
AT+CCUG
if available, the settings of the parameters
• The ME is equipped with a "Blacklist" function according to GSM02.07 Annex A:
After a predefined number of failed call attempts, the dialed number is entered into a read-only phonebook
called "blacklist" (phonebook "BL"). Call attempts to numbers contained in the blacklist will be barred by ME
and not signalled to the network.
An attempt to start a voice call to a barred phone number will be stopped with a CME ERROR 257 "Call
Barred".
An attempt to start a data or fax call to a barred phone number will be answered immediately with result code
"NO CARRIER".
The barred numbers are automatically removed from the blacklist according to the timing conditions specified
in GSM02.07 Annex A.
• To start the command automatically on DTR signal activation
ATD
TC35i_ATC_V02.07
Confidential / Released
.
<index>
Page 144 of 439
command during execution. It cannot be
ATH
.
ATDL
and made with
<info>
may be used.
AT%D
s
m
obile
AT+CUSD
.
AT+CCUG
1/30/04
).