Document Conventions; Quick Reference Table - Siemens TC35i User Manual

Terminal hardware interface
Hide thumbs Also See for TC35i:
Table of Contents

Advertisement

TC35i AT Command Set

1.3 Document conventions

1.3
Document conventions
Throughout the document, the GSM engines are referred to as ME (Mobile Equipment), MS (Mobile Station), TA
(Terminal Adapter), DCE (Data Communication Equipment) or facsimile DCE (FAX modem, FAX board). When
the Siemens product names are required to distinguish the two models, TC35i is short for the engine type and
TC35iT for the terminal.
To control your GSM engine you can simply send AT Commands via its serial interface. The controlling device
at the other end of the serial line is referred to as TE (Terminal Equipment), DTE (Data Terminal Equipment) or
plainly 'the application' (probably running on an embedded system).
All abbreviations and acronyms used throughout this document are based on the GSM specifications. For defi-
nitions please refer to TR 100 350 V7.0.0 (1999-08), (GSM 01.04, version 7.0.0 release 1998).
1.3.1

Quick reference table

Each AT command description includes a table similar to the example shown below. The table is intended as a
quick reference to indicate the following functions:
PIN:
Is the AT command PIN protected?
%
Yes
!
No
§
Usage is dependent on conditions specified for the command, or not all command types are PIN
protected (for example write command PIN protected, read command not).
Note: The table provided in the Chapter
uses the same symbols.
ASC0: Is the AT command supported on the physical serial interface ASC0?
%
Yes
!
No
Note: In the case of TC35i only "Yes" applies.
MUXn: Is the AT command usable on the Multiplexer channels MUX1, MUX2, MUX3?
%
Yes
!
No
§
AT command is usable, but under the restrictions specified in the chapter related to the com-
mand.
Note: The columns MUX1, MUX2 and MUX3 are relevant only when the GSM engine operates in Mul-
tiplexer mode, that is, when the physical serial interface is partitioned into 3 virtual channels by
using the Multiplexer protocol. Usage is the same on ASC0 and MUX1.
Example:
PIN
ASC0
MUX1
!
%
§
TC35i_ATC_V02.07
Confidential / Released
Available AT Commands and Dependency on SIM PIN
MUX2
MUX3
§
§
Page 14 of 439
s
m
obile
1/30/04

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tc35i terminal

Table of Contents