Siemens TC35i User Manual page 122

TC35i AT Command Set
5.4 AT+CLCK
(num)
<status>
0
1
(str)
<password>
Password string used to lock and to unlock a
in question and are therefore listed in the section on parameter
<facility>
modified with
AT+CPWD
(num)
<class>
Integer or sum of integers each representing a class of information, i.e. a bearer service, telecommunication ser-
vice or bearer service group as defined in "GSM 02.04".
1
2
4
8
16
32
64
128
1...[7]...255
Notes
• The AT+CLCK command offers the full range of
However, when you attempt to use a service option which is not provisioned or not yet subscribed to, the set-
ting will not take effect regardless of the response returned.
The responses in these cases vary with the network (for example "OK", "Operation not allowed", "Operation
not supported" etc.). To make sure check the extended error response with
=2.
<mode>
• The command has been implemented with the full set of
actual applicability of a desired Call barring service to a specific service or service group (a specific
value) please consult table A.1 of GSM 02.04.
• If an outgoing Fax or Data Call is rejected due to an active ''call barring'' supplementary service, the call will
be terminated with result code NO CARRIER.
Under the same conditions, an outgoing Voice call will be terminated with result code NO DIALTONE.
TC35i_ATC_V02.07
Confidential / Released
lock is inactive
lock is active
<facility>
or .
AT^SPWD
voice
class 2 ("data") comprises all those individual data classes between 16 and
128, that are supported both by the network and the MS. This means, a setting
made for class 2 applies to all individual data classes (if supported). In addition,
you can assign a different setting to a specific class. For example, you can acti-
vate Call Forwarding for all data classes, but deactivate it for data class 64,
"dedicated packet access".
fax
SMS
data circuit sync
data circuit async
dedicated packet access
dedicated PAD access
combination of some of the above classes.
For example, the default setting 7 represents the sum of the integers 1, 2 and
4 (voice, data and fax).
The value 255 covers all classes.
If parameter "class" is omitted, the default value 7 is used.
Page 122 of 439
. Length and authority for passwords depend on the
parameters according to the GSM specifications.
<class>
parameters according to GSM 07.07. For
<class>
s
m
obile
. Passwords can be
<facility>
and the lock status with
AT+CEER
<class>
1/30/04