Siemens TC35i User Manual page 296

TC35i AT Command Set
11.11 AT+CNMI
• Requirements specific to Multiplex mode:
In multiplex mode (
AT+CMUX
and on the other channels have to be set to zero. If either a SM or a Status Report is not acknowledged,
<ds>
all parameter in all channels will be set to zero.
AT+CNMI
• Handling of Class 0 short messages:
If the host application is provided with a display and
be displayed immediately.
If the host application does not include a display, ME handles Class 0 short messages as though there was
no message class, i.e. it will ignore bits 0 and 1 in the
shall apply. This approach is compliant with GSM 03.38 .
• The parameters
<ra>
• Filler "FF" will not be displayed in PDU status reports if the parameter
to 1.
• If either a SM or a Status Report is not acknowledged, all
zero.
• If the ME operates on different instances (MUX channels 1, 2, 3) avoid different settings for routing and indi-
cating SMS. For example, if messages shall be routed directly to one instance of the TE (set with
), it is not possible to activate the presentation of URCs with
AT^SSDA
instance. Any attempt to activate settings that conflict with existing settings on another interface, will result in
CME ERROR, or accordingly CMS ERROR.
TC35i_ATC_V02.07
Confidential / Released
=0) only one channel can use a phase 2+ parameter. The parameter for
and will only be displayed if
<tora>
Page 296 of 439
=1 has been set Class 0 short messages can
AT^SSDA
and normal rules for exceeded memory capacity
<dcs>
of the
<ra> AT^SSCONF
of
<ff>
parameters in all channels will be set to
AT+CNMI
AT+CMER
s
m
obile
<mt>
command is set to 1.
command is set
AT^SSCONF
AT+CNMI
or on another
AT+CNMI
1/30/04
,