Network; Wan Port; Vlan; Webserver Type - Fortinet FortiFone FON-570 User Manual

• Outbound Proxy 1: set the IP address or FQDN of the outbound proxy.
• Outbound Proxy 2: set the IP address or FQDN of the secondary outbound proxy.
• Proxy Fallback Interval: set the amount of seconds to wait before using the secondary
Outbound Proxy.
• NAT Status: enable or disable the use of STUN.

Network

WAN port

This section is for configuring the phone's network access. By default, DHCP is selected.
To set a static IP address:
1. Select Static IP.
2. Enter the static IP address.
3. Enter the Subnet Mast for the LAN.
4. Enter the IP address of the Default Gateway on your network. The router may act as the
Default Gateway.
5. Enter the IP address of the Pri. DNS. The gateway may act as the DNS server.
6. If applicable, enter the IP address of the Sec. DNS.
7. Tap Save.

VLAN

This section allows you to configure VLAN tags in accordance with IEEE 802.1 standards on the
WAN and/or PC connections.
To configure VLAN:
1. Select WAN Port, PC Port or DHCP VLAN.
2. Set VLAN Status to On.
3. Enter a VID Number. This is the VLAN tag identification number. For DHCP VLAN enter the
Option.
4. Set the Priority.
5. Tap Save.

Webserver type

This section allows you to configure the protocol(s) that will be used to access the web server.
By default, HTTP and HTTPS are enabled.

802.1x

To enable 802.1x:
1. Select the mode you would like.
2. Enter the phone Identity.
3. Enter the MD5 Password for the network.
Configuration Overview Page 13 FortiFone User Guide