Connection To An Ethernet/Ip Coupler Unit - Omron Sysmac NX-PD1000 User Manual

Appendices
NX Unit
Model
NX-PD1000
NX-PF0630
NX-PF0730
NX-PC0020
NX-PC0010
NX-PC0030
NX-TBX01
A-6-2

Connection to an EtherNet/IP Coupler Unit

The relationship between the unit versions of each Unit, EtherNet/IP Coupler Unit, CPU Unit and Indus-
trial PC, and versions of the Sysmac Studio and NX-IO Configurator are shown below.
Relationship between Unit Versions of Units
The items that are used in the version combination tables are given below.
NX Unit
Application with an NJ/NX/NY-series Control-
Unit ver-
Model
sion EtherNet/IP
Coupler Unit
Model Unit ver- Unit version of
number sion of the EtherNet/IP
of NX NX Unit Coupler Unit
Unit that is compat-
ible with the
NX Unit
The version combination table is given below.
• With the combinations of the unit versions/versions shown below, you can use the functions that are
supported by the unit version of the Unit model. Use the unit versions/versions (or the later/higher
unit version/versions) that correspond to the NX Unit models and the unit versions. You cannot use
the specifications that were added or changed for the relevant NX Unit models and the unit versions
unless you use the corresponding unit versions/versions.
• Depending on the type and model of the Unit to which the NX Unit is connected, some Units do not
have the corresponding versions given in the table. If a Unit does not have the specified version, sup-
port is provided by the oldest available version after the specified version. Refer to the user's manu-
als for the specific Units for the relation between models and versions.
• If you use the corresponding unit versions/versions given in the following table or later/higher ver-
sions, refer to the version information in the user's manual for the Communications Coupler Unit,
CPU Unit, and Industrial PC.
A - 28
Unit version
Coupler Unit
Ver. 1.0 Ver. 1.0
Corresponding unit versions/versions
ler
CPU Unit or
Industrial PC
Unit version of
NJ/NX-series
CPU Unit or
NY-series
Industrial PC
that is compati-
ble with the
EtherNet/IP
Coupler Unit
Corresponding unit versions/versions
EtherCAT CPU Unit or
Industrial PC
Ver. 1.05
Application with a CS/CJ/CP-series PLC
Sysmac Stu- EtherNet/IP
dio Coupler Unit
Sysmac Stu- Unit version of
dio version EtherNet/IP
that is compat- Coupler Unit
ible with the that is compat-
NX Unit, Eth- ible with the
erNet/IP Cou- NX Unit
pler Unit, CPU
Unit, and
Industrial PC
NX-series System Units User's Manual (W523)
Sysmac Studio
Ver. 1.06
Ver. 1.08
Ver. 1.06
Sysmac Stu- NX-IO Con-
dio figurator
Sysmac Stu- NX-IO Config-
dio version urator version
that is compat- that is compat-
ible with the ible with the
NX Unit, Eth- NX Unit, Eth-
erNet/IP Cou- erNet/IP Cou-
pler Unit, and pler Unit, and
CPU Unit CPU Unit