Omron Sysmac NX-PD1000 User Manual page 104

4 Installation and Wiring
2
Leave the flat-blade screwdriver pressed into the release hole and insert the twisted wire or the
solid wire into the terminal hole.
Insert the twisted wire or the solid wire until the stripped portion is no longer visible to prevent
shorting.
3
Remove the flat-blade screwdriver from the release hole.
After you make a connection, make sure that the twisted wire or the solid wire is securely connected
to the terminal block.
4 - 44
2
Twisted wire/Solid wire
3
NX-series System Units User's Manual (W523)