A-6-2 Connection To An Ethernet/Ip Coupler Unit - Omron NX-ILM400 User Manual

Appendices
A-6-2 Connection to an EtherNet/IP Coupler Unit
This section describes the relationships between the unit versions of each Unit, EtherNet/IP Coupler
Unit, CPU Unit and Industrial PC, versions of the Sysmac Studio, NX-IO Configurator and CX-Configu-
ratorFDT, and the specification changes for each unit version of each Unit.
Relationship between Unit Versions of Units
The items that are used in the version combination tables are given below.
 When Using an NJ/NX/NY-series Controller
The items that are used in the version combination tables are given below.
Model
Model numbers
of NX Units.
The version combination table is given below.
• With the combinations of the unit versions/versions shown below, you can use the functions that
are supported by the unit version of the Unit model. Use the unit versions/versions (or the
later/higher unit versions/versions) that correspond to the NX Unit models and the unit versions.
You cannot use the specifications that were added or changed for the relevant NX Unit models
and the unit versions unless you use the corresponding unit versions/versions.
• Depending on the type and model of the Unit to which the NX Unit is connected, some Units do
not have the corresponding versions given in the table. If a Unit does not have the specified ver-
sion, support is provided by the oldest available version after the specified version. Refer to the
user's manuals for the specific Units for the relation between models and versions.
• If you use the corresponding unit versions/versions given in the following table or later/higher ver-
sions, refer to the version information in the user's manual for the Communications Coupler Unit,
CPU Unit, and Industrial PC.
Models
NX-ILM400
*1. Refer to the user's manual of the EtherNet/IP Coupler Unit for the unit versions of EtherNet/IP Units cor-
responding to EtherNet/IP Coupler Units.
*2. The CX-ConfiguratorFDT with version 2.2 or higher can be used if it is connected to the peripheral USB
port on the EtherNet/IP Coupler Unit.
A - 40
NX Unit
EtherNet/IP
Unit version
Coupler Unit
Unit versions of Unit versions of
NX Units. Ether-Net/IP
Coupler Units
that are com-
patible with the
NX Units.
NX Unit
EtherNet/IP
Unit version
Coupler Unit
Ver.1.0 Ver.1.2
Ver.1.1
Corresponding unit version/version
CPU Unit or
Sysmac Studio
Industrial PC
Unit version of Sysmac Studio
the versions that
NJ/NX-series are compatible
CPU Units or with the NX
NY-series Units, Ether-
Industrial PCs Net/IP Coupler
that are com- Units, CPU
patible with the Units, and
EtherNet/ IP Industrial PCs.
Coupler Unit.
Corresponding unit version/version
CPU Unit or
Sysmac Studio
Industrial PC
Ver.1.14 Ver.1.19
Ver.1.20
NX-series IO-Link Master Unit User's Manual (W567)
CX-Configura-
torFDT
The version of
the CX-Configu-
ratorFDT that
supports the
IO-Link Master
Unit.
*1
CX-Configura-
torFDT
*2
Ver.2.4