Printer Installation; Use The Bolt-Down Feature - DataCard CR500 Installation And Administrator's Manual

Printer Installation

To install the CR500 printer, place the printer on the selected work surface. Make sure that the
work surface meets the requirements described in
the following procedures:
1.
(Optional) Use the bolt-down feature to secure the printer to the work surface.
2.
Plug in the power cords to the print unit and the security enclosure.
3.
Connect the data network cable to the printer.
4.
Power on the printer to verify it initializes correctly.
5.
Run the appropriate single-sided cleaning card through the printer.
6.
Install the concealed output stacker onto the printer.

Use the Bolt-Down Feature

Use the optional bolt-down feature to secure the printer to the work surface.
To use the printer's bolt-down feature, you must provide the following parts and tools:
A bolt that meets the following requirements:

The bolt size is 1/4-20 UNC: the diameter is 1/4 inch, with 20 threads per inch. Do not use

a metric-sized bolt in place of the UNC bolt.
The bolt cannot intrude into the printer by more than 1 inch (25.4 mm).

The bolt length must be the thickness of the work surface, plus the thickness of the

washer, plus the thickness of the spacer, plus 1/4 inch to 1 inch going into the rivet nut in
the bottom of the printer.
For example, if your printer's work surface is 1-1/2 inches thick, the bolt length can be
from 2-3/8 to 3-1/8 inches, as shown in the following table:
Work Surface
(example)
1-1/2 inch
1-1/2 inch
A drill with a bit the appropriate size for the bolt. The hole must be smaller than the

15/16 inch (23.8 mm) diameter of the provided washer.
16
Washer Spacer
+ Thickness + Thickness
+ 1/16 inch + 9/16 inch
+ 1/16 inch + 9/16 inch
"Work Surface" on page
Rivet Nut
+ Depth
+ 1/4 inch
(minimum)
+ 1 inch
(maximum)
12. Then, perform
Desired
= Bolt Length
= 2-3/8 inch
(minimum)
= 3-1/8 inch
(maximum)
Install the Printer