Power On The Printer - DataCard CR500 Installation And Administrator's Manual

Power On the Printer

The first time you set up the printer, power on the printer without installing supplies, to release
transport mode. Keep the power on for about 30 seconds until a film search error displays on the
print unit front panel, and then power off the printer.
The printer is shipped in transport mode. Retransfer film cannot be installed while
the printer is in transport mode. Powering on the printer cancels transport mode.
1.

Power on the printer.

a.
Open the security enclosure door, so you can see the print unit front panel.
b.
Press the "|" symbol on the power switch to power on the printer.
Print Unit
Front Panel
2.
Follow the instructions in the printer's User's Guide to load the ink ribbon and retransfer film
cartridges.
3.
Install the ink ribbon cartridge in the printer. Do not install the retransfer film cartridge at this
time.
4.
Close the print unit door.
Continue with
CR500 Instant Issuance System Installation and Administrator's Guide
Power Switch
"Clean the Print Unit" on page 22.
21