Print - DataCard CR500 Installation And Administrator's Manual

Print

Use the Printer Setting menu Print options to control the quality of the printing.
Option
SettingsGroupPurpose
ApplyBendRemedy
BacksideCooling
BendRemedyRetransfer
RollerTemp
62
Description
Describes the purpose of a settings group. Use it to state the reason for
creating a settings group.
Enable or disable the bend remedy. Caution: Do not enable if you are
using smart cards.
Default: Disabled
Enable the bend remedy if completed cards are bowed. The card type
material can affect the amount of bowing.
Allows the card to cool between transferring the image to the front
side of the card and the back side of the card. This setting is valid only
during double-sided printing.
Default: Disabled
Enable BacksideCooling if cards are warped as they are ejected.

Disable BacksideCooling to improve print speed.

Increase or decrease the temperature of the bend remedy roller.
Range: –5 to 0 special units
Default: 0 special units
Increase the temperature value if using the bend remedy results in

concave cards.
Decrease the temperature value if using the bend remedy results in

convex cards.
Determine the BendRemedyRetransferRollerTemp value to use based
on the card type material and the BendRemedyVelocity. (Bend remedy
velocity is a WebService setting. Contact your service provider for
assistance.) Print sample cards to determine the appropriate settings
for your card type.
Using Printer Manager