Datacard CE870 User Reference Guide The CE870 Instant Issuance System The CE870 Instant Issuance System Contents The CE870 Instant Issuance System ............3 Common LCD Messages ................4 102: Card not in position ..................4 103: Printer problem ................... 4 104: Critical problem ...................
This section describes some of the common messages that may display. Use magnetic stripe cards that match the printer settings. Refer to “The CE870 Instant Issuance System” on page 3 for the location of the Make sure that the cards are placed in the printer correctly.
Datacard CE870 User Reference Guide Common LCD Messages 114: Cover opened during job 134: Indent ribbon low Cause: The indent ribbon is almost at the end of the roll. Cause: The printer cover was opened while printing. Check all printer doors to make sure that they are closed completely.
Datacard CE870 User Reference Guide Common LCD Messages 172: Insert cleaning card 144: Topping foil out Cause: The printer is ready to be cleaned. Cause: The topping foil has run out. • If the cleaning card is in the input hopper, press the USER button.
Datacard CE870 User Reference Guide Clean the Printer Clean the Printer Clean the Printer Enter the menu system. Prepare the Printer for Cleaning Follow the steps on the LCD panel (refer to the following illustration). Press the USER button to start the cleaning cycle when “Insert cleaning card”...
Datacard CE870 User Reference Guide Load Cards Load Cards Clean the Multi-Hopper Rollers Unlock and open the input hopper cover. • Fan the cards to separate the edges. Load cleaning cards into each hopper. • Insert ISO magnetic stripe cards with the stripe facing down and to the right.
Datacard CE870 User Reference Guide Load the Indent Ribbon Load the Indent Ribbon Roll up one full turn of indent ribbon on the silver take-up spool. Roll out a slack length of indent ribbon from the supply spool. Unlock and open the embosser supplies door.
Datacard CE870 User Reference Guide Load the Topping Foil Load the Topping Foil Match the keyed pattern of the silver take-up spool hub with the left side spindle. Unlock and open the embosser supplies door. Push the take-up spool into the spindle until it clicks securely into place.
Replace the Cleaning Sleeve Load the Print Ribbon Replace the Cleaning Sleeve CE870 printers with the optional printhead only. Unlock the printer and open the printer supplies access door (multi-hopper). Unlock the printer and open the printer supplies access door (multi-hopper).
Datacard CE870 User Reference Guide Close the Printer Doors Empty the Reject Card Tray Close the Printer Doors Empty the reject card tray regularly to avoid card jams. Follow your site’s guidelines The printer cannot process cards while any access doors are open. Make sure that to dispose of the cards removed from the reject card tray.
Datacard CE870 User Reference Guide Check Data Connections Check Power Connections Check Data Connections Make sure that all power cables are securely connected. Make sure that all data cables are securely connected. Printer Power Connections Network Connection Printer-to-Embosser Connection Embosser Power Connections...