Update Password; Set Job Queue State - DataCard CR500 Installation And Administrator's Manual

Update Password

You can specify to password protect Printer Manager and limit access to the advanced settings.
Adding password protection is the preferred method of restricting access to Printer Manager. If
no password is assigned, a password is not needed to log on to Printer Manager.
Do the following to change the password:
1.
Select the access level for which you want to assign a password. The WebAdmin access level
can update the WebAdmin, WebUser, SnmpRwCommunity, and SnmpRoCommunity
passwords.
2.
Enter the current password. If a current password is not set, leave this field blank.
3.
Enter the new password in the corresponding field. To remove a password, leave this field
blank.
4.
Enter the new password again to confirm it. Leave the field blank if you are removing the
password.
5.
Click Update Password to apply the changes.
H & T
INTS IPS
Passwords are hierarchical in the following order: WebService, WebAdmin, and WebUser. You

can use a password that is higher in the hierarchy to log on to a specific role.
Passwords may contain the following characters: a–z, A–Z, 0–9, +, and /.

Caution: Do not change the WebService password.

Set Job Queue State

Enter or select values prior to shipping the printer or system to or from repair facilities.
Refer to "Set Job Queue State"
CR500 Instant Issuance System Installation and Administrator's Guide
on page 55 for more information.
69