Honda 1986 GoldWing GL1200A Manual page 81

Injector Coli Inspection
With the engine stopped and the ignition switch ON
check the wiring tor continuity by observing the LED's.
NOTE: Be sure couplers are connected securely.
Tum the ignition switch OFF. Disconnect the injector
coupler and measure the resistance between the ter-
minals.
Standard: 1.55-1.85 ohms (20 0 C, 68 0 F)
-
Removaillnstallation
Disconnect the injector coupler. Remove the injector
cap. dust cover, suspension ring and shim. Keep all
removed parts In their original sets.
Install parts in the reverse order of removal. Apply a thin
coat of clean engine oil to the injector a-ring, and the in-
take pipe mating face. Use only dowel bolts to install the
Injector cap.
Shim Selection
O-RING
COLOR CODE STAMP
SHIM SELECTION TABLE
Unit: mm(ln)
INJECTOR
NOTE: Injectors must be adjusted with shims when any
of the following parts are replaced:
• Fuel injector
• Fuel delivery pIpe
• Fuel injector cap
• Throttle body
• Intake pipe
Shim only the affected Injector.
Determine the Injector color code.
Measure the distance ilL" between the cap end and intake
pipe injector mating face.
select a shim from the table based on the "L" distance
and color code.
~
58.5 (2.30 59.0 (2.32 59.5 (2.34 160.0 (2.36
Injector
to to to
to
Color Code
59.0 (2.32 59.5 (2.34 60.0 (2.36 60.5 (2.38
Yellow
Green
Brown
Black
No color
0.5 mm t.Omm 1.6 mm 2.0 mm
code
(0.02Inl (0.04 In)
(0.06Inl (0.08 In)
Blue
Shim not
Yellow
Green
Brown
used
INJECTOR
CAP
10-21