Honda 1986 GoldWing GL1200A Manual page 156

Clutch
Disconnect the BI'Y and GfBu wires from the terminals on
the cruise cancel sWitch.
Check for contlnuity between the switch terminals.
Clutch lever released' No continuity
Clutch lever pulled In: Continuity
Throttle
Disconnect the throttle cancel switch coupler from the
wire harness
Check for continuity at the 2P coupler just left of the
crUIse control unit
Throttle closed: Continuity
Further return: No continuity
To adjust. remove the fuel strainer from the left engine
mount bracket.
Disconnect the left throttle link arm from the throttle arm.
Loosen the adjusting bolt lock nut.
Connect an ohmmeter to the switch wires and turn the
adjusting bolt until "continuity" shifts to "no continuity".
Back off the adjusting bolt
2-1;3
rotations and tighten the
lock nut.
NOTE Replace the switch if continUity or no contlnuity
falls to shift.
(cont'd)
1
I
~
......
~ ~======-<c>"",-<==;:....=".=l_/
TH~'NKARM :J~:
::::;:===1/ /
: I /
//
\
...
:
,.:
...
/'
13-17