January 2016
Outriggers
10-1
Outrigger Components
How to Remove an Outrigger
Outriggers are essential to safe machine operation
and machine stability. Operating a machine with
a damaged or improperly operating outrigger will
result in death or serious injury.
Note: Perform this procedure with the machine
disconnected from the tow vehicle and the parking
brake applied.
Note: Perform this procedure with the outriggers in
the stowed position.
1 Attach a lifting strap of suitable capacity from
an overhead crane to the pad end of the
outrigger. Do not apply any lifting pressure.
2 Tag and disconnect the wire harness from the
outrigger valve coil.
3 Tag, disconnect and plug the hydraulic hoses at
the outrigger cylinder. Cap the fi ttings.
4 Remove the pin retaining fasteners from the
outrigger pivot pin. Do not remove the pin.
Part No. 825934
5 Remove the pin retaining fasteners from the
outrigger cylinder barrel-end pivot pin.
6 Place a rod through the hole in the outrigger
cylinder barrel-end pivot pin and twist to
remove the pin. Remove the pivot pin from the
machine.
7 Place a rod through the hole in the outrigger
pivot pin and twist to remove the pin. Remove
the outrigger pivot pin from the machine.
8 Remove the outrigger and cylinder from the
machine.
Genie TZ-34/20
Section 4 • Repair Procedures
Crushing hazard. The outrigger
could fall if not properly supported
when the pivot pin is removed
from the machine.
Crushing hazard. The outrigger
will fall if not properly supported
when the pivot pin is removed
from the machine.
4 - 37