Removing The Steering Arm; Installing The Steering Arm - Yamaha 250GETO Service Manual

Removing the steering arm

1. Remove the circlip 1.
2. Remove the steering yoke 2 as shown.
a
3
NOTE:
Use a spacer 3 ( a= 30 mm) and gear puller
4 (commercially available).
3. Remove the steering arm from the swivel
bracket by pulling the arm off the bracket.
6S35H11

Installing the steering arm

1. Install the washer 1 and bushing 2 onto
2. Place the swivel bracket 4 in an upright
1
S69J7075
2
3. Install the bushing 5, new O-ring 6,
4
6S370010
Upper case, steering arm
the steering arm 3.
position, and then install the steering arm
onto the swivel bracket assembly
bushing 7, and washer 8 onto the swiv-
el bracket assembly.
1
2
3
4
5
6
7
8
9
7-14