Disassembling the PTT motor
1. Remove the PTT motor, O-ring, and joint
from the PTT unit.
w
9 Make sure that the trim and tilt rams are
fully extended when removing the PTT
motor, otherwise fluid can spurt out
from the unit due to internal pressure.
9 Do not push the trim and tilt rams down
while the PTT motor is removed from the
PTT unit, otherwise fluid can spurt out.
2. Remove the PTT motor bolts 1, then the
stator 2.
cC
Do not allow grease or oil to contact the
commutator.
NOTE:
Place a clean cloth over the end of the arma-
ture shaft, hold it with a pair of pliers, and
then carefully slide the stator off of the arma-
ture.
6S35H11
3. Remove the stator 2 and O-ring 3.
4. Remove the screws 4 and slide the
holder, and then disconnect the PTT
motor leads 5.
2
5
1
6S370120
5. Remove the brushes 6 and springs 7.
3
2
4
B
7
6
7
PTT motor
1
2
6S370130
3
4
4
Lg
5
B
5
Sb
6
6S370135
7
8
9
7
7
6S370145
7-28