Checking The Propeller Shaft Housing; Checking The Propeller Shaft; Assembling The Propeller Shaft Assembly - Yamaha 250GETO Service Manual

LOWR
2. Remove the ball bearing from reverse
gear, and then remove the reverse gear
shims.
4
cC
Do not reuse the bearing, always replace
it with a new one.
Bearing separator 1: 90890-06534
Stopper guide plate 2:
90890-06501
Stopper guide stand 3:
90890-06538
Bearing puller assembly 4:
90890-06535
3. Remove the oil seals and needle bearing.
6
5
Needle bearing attachment 5:
90890-06653
Driver rod L3 6: 90890-06652
Checking the propeller shaft hous-
ing
1. Clean the propeller shaft housing using a
soft brush and cleaning solvent, and then
check it. Replace if cracked or damaged.
6-9
Lower unit
2
3
1
6S360090
S6S16580
2. Check the teeth and dogs of the reverse
gear. Replace if cracked or worn.
3. Check the bearings. Replace if pitted or if
there is rumbling.

Checking the propeller shaft

1. Check the propeller shaft. Replace if bent
or worn.
2. Measure the propeller shaft runout.
Runout limit: 0.02 mm (0.0008 in)
3. Check the dog clutch, shift rod joint, and
slider. Replace if cracked or worn.
Assembling the propeller shaft
assembly
1. Assemble the propeller shaft assembly
as shown.
NOTE:
Face the marking side to original direction,
and then install the dog clutch 1.
S6P26200
1
6S360050
6S35H11