Checking The Upper Case; Assembling The Upper Case - Yamaha 250GETO Service Manual

Checking the upper case

1. Check the rubber dampers. Replace if
deterioration or cracks.
2. Check the cooling water pipe. Replace if
deformation or corrosion.
3. Check the exhaust guide, exhaust mani-
fold, and muffler. Replace if deformation
or corrosion.

Assembling the upper case

1. Install the drive shaft bushing into the
upper case, and then install the circlip.
1
NOTE:
After installing the drive shaft bushing, apply
grease to the inside of the bushing.
Needle bearing attachment 1:
90890-06653
Driver rod L3 2: 90890-06652
6S35H11
2. Install a new gasket 3, the lower exhaust
guide 4, and bolts 5, and then tighten
the bolts to the specified torque.
3
2
3. Install a new gasket 6, the exhaust man-
ifold 7, and bolts, and then tighten the
bolts to the specified torque.
S6P27850E
Upper case, steering arm
Exhaust guide bolt 5:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
6
Exhaust manifold bolt 8:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
1
5
2
4
3
S60V7190
4
5
8
6
7
7
S60V7200
8
9
7-10