Omron NT31 Operation Manuals page 65

Using a Memory Unit (NT31/NT31C with V1)
Reference
54
"Current PT Screen Data"–system
The first line
The second line : "System program name" and "Version" for the system
(The second line may not be displayed in the kind of system program.)
"Current PT Screen Data"–screen
The comment for the screen data in the NT31/NT31C is displayed here.
"Current Memory Unit Screen Data"
S In the case of system program:
The first line
The second line : "System program name" and "Version" for the system
(The second line may not be displayed in the system program for some
models.)
S In the case of screen data:
The comment for the screen data in the NT31/NT31C is displayed here.
The available "transmitting" destinations are altered depending on the settings of
the origin of "transmitting" as described in the table below.
Source
[PT]screen
[PT]system
[PT]system/screen
[Memory unit] Bank 0
[Memory unit] Bank 1
[Memory unit] Bank 0/1
- When transmitting the system program and screen data simultaneously from
the PT to the memory unit, the setting of banks is "Bank 0: system program,
Bank 1: screen data", and when transmitting them from the memory unit to the
PT, either of the following combinations must be used.
Bank 0: system program, Bank 1: other than system program
Bank 0: other than system program, Bank 1: system program
- When writing the system program into the NT31/NT31C, the type of system pro-
gram inside memory unit and the type of PT unit must be corresponding.
: "Compatible PT type" for the system program inside
PT.
program inside PT.
: "Compatible PT type" for the system program inside
the memory unit.
program inside the memory unit.
[Memory unit] Bank 0
[Memory unit] Bank 0/1 (fixed)
S If system program is selected
[PT]system (fixed)
S
If screen data is selected
[PT]screen (fixed)
[PT]system/screen (fixed)
Section 3-5
Destination
[Memory unit] Bank 1